Filling the deck seams (first run)

Starting my seventh week of construction on my new Pygmy Borealis XL build. Making great progress so far and it's going quickly!

This morning I woke up to a deck that was firmly epoxied onto the hull. Phew!

Tonight, and tomorrow night too, was for filling the seams with thickened epoxy. Because the epoxy from last wasn't fully cured, I left the tape on the hull and only filled where I added epoxy last night.

Tomorrow night I will remove the tape and fill the gaps with thickend epoxy. This is also a great time to fill any of the other seams that need it with thickened epoxy too, if only to help color-match them with the rest of the boat.

Once the seams are filled and cured I will sand the deck and hull/deck joint to get ready to fiberglass the deck... the last BIG fiberglass job on the boat!

Peace!

Comments

The Rogue Manual

I've posted about this earlier, but thought it might be good to post it again for anyone who may be interested. I've started to write a manual of tips and tricks for Pygmy solo kayak builders. It covers the taping method, so that your boat doesn't have hundreds of holes all over it. I'm on version 2 now. Version 2 covers several other tips and tricks from myself and from others as collected over time. ATTENTION : Use the manual at your own risk! The only person responsible for any mistakes or problems with the building of your boat is you. Always use the official Pygmy manual that came with your kit. Only do those tips and tricks that make sense to you. If something in the manual doesn't sound right to you, then don't do it! Neither I, nor Pygmy Boats, nor anyone else except YOU is responsible for the safety of your boat and the quality of your build. It's in very rough draft form right now, but if you'd like to read it, please send a $10 donat...

The Pygmy Pinguino 145 Kayak is Completed!

Ta Da! I finally finished it. Haven't been able to blog much about it, but here's how it looks... It has four coats of varnish on both the hull and deck. It probably should have had six or more, but I'm tired. I made my own padeyes, and I opted to not install a perimeter line yet. My friend who I built this for is a very casual user and this is probably sufficient for her, but perimeter lines would be a nice safety feature though. That's it! Until next time, I'm signing out for now.... Cheers!

Waterlog Surfboard Build, Part 2

Since my last post I've made a lot of progress. I've completed the rails and the landing strips. Here is the chine log being epoxied in. By the way, I'm using epoxy for much of this. I ended up using Titebond III for most of the rails because they didn't have a lot of force on them and I could get them clamped down quickly (Titebond III sets quickly). But for anything that has any stress on it, I'm using WEST System epoxy that I have left over. The nose strips had to be steamed. Read the manual for how to do this. It works well enough. For the landing strips (the 'lands'), I'm doing the "alternative" method that is shown in one of Grain's tutorial videos . I'm running the outside one out the ends. It worked out well and I'd definitely recommend you do it instead of the convoluted approach they say in their manual. I would expect that at some point in the future that they make this the primary way to do it and change their m...

Search This Blog